Pocket Door Hardware Instructions

Prime line 2 pack 1 125 in plastic pocket door bottom guide.

Pocket door hardware instructions.

Wherever you purchased your pocket door hardware start by reading the directions that come with the door hardware that you purchased. Fasten split header on 1121 lock lever side with screws for future door removal or adjustment. Attach the split studs to the floor and to the header checking for plumb. Do not use jambs with dado s.

Nail the end plate to the wall studs. Purchase a pocket door kit at a hardware store. 1 574 293 5664 m f 8 00am 5 00pm est. Install the header and track assembly on the top jamb with the fasteners and brackets supplied with the door.

Johnson hardware pocket door hardware. Its door panels are adjustable up to 5 8 in. The door rides through a channel made by what are called split studs these studs function like regular wall studs but are metal wrapped and form a hollow channel in the middle for the pocket door to pass through. Door hardware knobs pulls supports catches latches all categories.

For doors inch thick install the track flush with the header. Install the track according to the thickness of the header. Répétez l opération avec l autre roulette et attache de porte. Make sure that the hardware is for the thickness and the type of door that you are installing the hardware for and take note of any warnings or special notes the manufacturer gives.

Higher than the door panel height. Pocket door frame set is designed for use with doors up to a maximum of 80 in. High and 1 3 4 in. Most are under 100.

Check that the track is level so that the door rolls easily. Step 1 read the directions. If needed use a hand saw to cut the track that came with your pocket door hardware so that it s 1 8 inch shorter than the opening. Install finished jambs split header and casing as shown.

Once the frame is in place it s time for the pocket door installation. This kit should contain the door split studs that allow the door to retract into the wall a track on which the door runs into the wall and door hardware. Follow the manufacturer s instructions and cut the pocket door header and track assembly to length with a hacksaw. Pocket door frame set the everbilt 36 in.

You may be able to find pocket doors at lumberyards too. Vertically and the door rough opening should be 4 in.